Code : CO 430 CON / CO 430 CON ROTARY
Capacity: 430 Ltr.
Outer Dimensions: 35 x 46 x 60 inch (W x D x H)
Electrical Load: 6000 Watts
Outer body: Stainless Steel
Inner body : Stainless Steel
Digital Thermostat with display
With motor & blower for hot air circulation
Temperature : upto 300°C
For Rotary : Fixed trolley & removable trays
GI trays - 14 nos. - (15 x 15 inch)
SS Door with toughened see-through glass
Double insulated outer body
High insulated fiber glass wiring
All electrical parts ISI marked
CO – 430 ROTARY Instruction Manual
TECHNICAL SPECIFICATIONS
PARAMETER CO – 430 Rotary
Capacity 430
Trays 15” x 15” – 14nos.
Outer dimensions (inches) approx. 35” x 34” x 60”
Consumption (W) / 230V 5000
Temperature control Digital
INSTRUCTIONS FOR USE
INSTALLATION
Your Convection oven is completely assembled. Before using your oven remove all packing material and tape.
ELECTRICAL REQUIREMENTS
All models require 230V, 50Hz supply. It is company’s recommendation that this machine be plugged directly into a
wall outlet. The use of extension cords is not recommended due to safety reasons and the oven performance will be
sacrificed / reduced.
CONTROL PANEL
Description:-
1. Digital Display
2. Relay indicator light
3. Push Buttons to set temperature
4. Set temperature display
5. Knob with 3 positions (OFF, ON, MOTOR ON (Blower))
6. Toggle Switch for Trolley Motor ON-OFF
7. Power on indicator light
METHOD
Check for all controls to be at off position.
Insert the 15 Amp plug in the mains socket.
Turn the knob to “On” position in the clockwise direction, this will supply power to your oven
& digital display(Item 1) will show the room temperature & power indicator light (Item 6) will
turn on.
Set the desired temperature by pressing the buttons, (item 3). To increase the digit press the
upper buttons, to decrease the digit press the lower buttons. If the temperature on the
display is less than the set temperature, relay light R (item 2) will keep glowing. Maximum
temperature 299° C.
Then turn the knob to “Motor on” position in the clockwise direction, this will switch on the
motor & two blowers (convection system) in the oven.
Turn the toggle switch (Item 6) in down position which will switch on the rotary mechanism &
the trolley starts rotating.
After the set temperature is attained, the relay light (item 2) will start blinking & power to
heaters get disconnected. Relay then works to maintain the temperature.
After usage, turn knob to “OFF” position in the clockwise direction, toggle switch in up
position & set the temperature to 0 0 0.
SAFETY PRECAUTIONS
CAUTION
This machine must only be operated by qualified person(s) who are fully versed in the operating and safety instructions described in this
manual. Servicepersons should be instructed to familiarize themselves with any and all safety instructions described in this manual prior to
commencement of any maintenance or service.
WARNING
Also note that the oven should be given rest periodically for better performance and long life
Always when opening the door switch off the motor as the blowers tend to suck cold air from outside.
Disconnect the appliance from electrical supply before cleaning or servicing.
In case of fire disconnect the appliance from its power source immediately.
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.